The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Don
« on: June 23, 2016, 09:42:02 PM »

Bob, looks like you are correct.  Wont work on the 3A without a lot of work, so perhaps it can help fund the rest of the rebuild.

Anyone have an idea of its value?
Posted by: Bob W
« on: June 20, 2016, 10:15:58 PM »

Kinda looks like a Model 40 to me. That would be for a wagon or truck. Check out Art's website here...
http://48cj2a.com/PTOs.htm
Posted by: johnrb3b
« on: June 20, 2016, 09:23:55 AM »

It's a front PTO drive.
Probably work with any D-18.
The length from the transfer case hole out to the PTO shaft hole might vary by vehicle - mostly determined by vehicle width, but it's possible they were all the same.

Anybody out there know?
Posted by: Don
« on: June 19, 2016, 11:04:04 PM »

All
I have a model 50 PTO, pulled it apart today and verified that it is good internally and buildable.� But after looking at some photos and documentation online I am wondering is this for a CJ, or something like an FC.� Any input would be appreciated.
Don