The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: scoutpilot
« on: May 01, 2019, 06:42:48 AM »

Check the fuel pressure. Don't trust the controller.
Posted by: PhilipS
« on: April 30, 2019, 03:30:02 PM »

Cold, I pull the choke and turn the key. the engine tries to start then gas starts blowing back out the carb.  Also as a side note, I have NO spacer on the fuel pump.
Hot, turn the key.
Posted by: scoutpilot
« on: April 30, 2019, 03:23:00 PM »

Tell me about your cold and warm starting procedures. Don't leave out any steps.

HINT: Pumping the accelerator pedal before starting will immediately flood the Solex.
Posted by: PhilipS
« on: April 30, 2019, 03:17:22 PM »

I have a 1949 CJ3A with the L134 and a new Solex carb. When I go to start it I get gas filling the intake manifold and blowing out the Carb and will not start. I have a fuel regulator set at 1.5 but that makes no difference. The carb has been rebuilt and checked. Any suggestions?