The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: bverboy
« on: June 25, 2019, 08:38:46 PM »

 :D
Posted by: stony
« on: June 25, 2019, 06:16:59 PM »

Yeah my bellhousing came out of a 49 Jeepster which has the clutch fork on the right side, my 3A has the clutch fork on the left side.
Posted by: Bob W
« on: June 24, 2019, 08:48:07 PM »

Originally there was no boot on the opening with the clutch linkage.
Posted by: Andrew
« on: June 24, 2019, 07:48:31 PM »

Walcks "tin plate" hole cover is for closing the  hole not used. What I'm looking for is the rubber boot used around the clutch fork in the hole that is used.Hole measures 1-1/8" high x 2-1/8" wide.
Posted by: Rus Curtis
« on: June 24, 2019, 03:08:14 PM »

Quote
It's a sheet metal cover with small radius corners about 1/8" or so.
Has� a screw at center which holds it into position via another smaller sheet metal plate on the inside.


Well, that describes Walck's part in detail.  Looks like I need to add this part to my list!
Posted by: oldtime
« on: June 24, 2019, 10:11:52 AM »

It's a sheet metal cover with small radius corners about 1/8" or so.
Has  a screw at center which holds it into position via another smaller sheet metal plate on the inside.
Posted by: Rus Curtis
« on: June 23, 2019, 11:03:03 PM »

My 3B has two holes, but I don't think I've ever heard of one of these.� But, then again, I haven't heard of a lot....

I dug out my CJ3B Parts Manual and found this:

GROUP 10-22 - FLYWHEEL HOUSING
649553� �� Cover, hole, clutch control lever, assembly (To cover hole in flywheel housing)

I went ahead and used google and up pops Walcks.

https://walcks4wd.com/bell-housing-cover-clutch-control-1946-1952-cj3a-pick-up-truck-station-wagon-sedan-delivery-jeepster.html

Hope this is what you're after.
Posted by: Andrew
« on: June 23, 2019, 10:45:12 PM »

My 3A has a 641020 1 bellhouse with clutch fork holes on each side for LHD or RHD.  Is there any source for the rubber clutch fork boot?  Part #?  This same bellhouse was apparently also used on some wagons & trucks in the go-devil L Head years.  Thanks