The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: CJPilot
« on: April 14, 2016, 07:17:54 AM »

I had to replace my brake light switch. It was a new one but as I tried to adjust the switch to fit the harness butt connectors it broke. After a little research I decided to go with the Crown Automotive P/N J0647801.  When it showed up the tag said it was made in the USA.  The fit to the harness butt connectors did not need to be adjusted and it installed just fine.  Only time will tell if it's going to work but at least it was supposedly made here.