The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: BillT
« on: November 13, 2018, 10:34:33 AM »

Thanks for the info Rick.

I'll see what media they use. He was concerned about the small wire being able to withstand the material. But he has not actually seen the screen yet.
Posted by: RICKG
« on: November 13, 2018, 09:25:29 AM »

Media is whatever, sand, glass bead, crushed walnut shell, whatever. I had a screen in the same condition and it cleaned up nice with a HF hobby blaster and sand. Low psi on the compressor.
Posted by: BillT
« on: November 12, 2018, 05:42:25 PM »

They use media, media blasting. What�s media?
Posted by: Rus Curtis
« on: November 12, 2018, 04:42:39 PM »

That's either 663550 or 663551 (not sure which) Chaff Screen and Brush Guard.  Replacements are offered from vendors (one listed as $83.95 while the other listed $225 -wow!)

So condition may be a big factor on its value. 

I don't know how well the fine screen material would hold up to blasting.
Posted by: BillT
« on: November 12, 2018, 03:45:20 PM »

I took the brush guard off my Jeep, I like the look better without it.
I don�t know if this is an original guard or an aftermarket one. Is there any demand for these, any value? I haven�t decided if I�m going to sell it yet, just curious.
The po put a fairly heavy coat of paint on it, thought I would take it to NAPA and get it blasted and primed.[reason]Add info[/reason]