The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: macrisel
« on: February 03, 2017, 03:54:41 PM »

While I haven't used them myself, I believe several people have had good luck with Classic Enterprises.

Here is their link:
http://www.classicent.com/jeep/

Good luck!
Mark
Posted by: Roger
« on: February 01, 2017, 11:02:37 PM »

Question... I had replaced the partial floor sections on my 3A and not at all pleased with the results... warped and did not replace all of the rust.  Looking at possibly just cutting it out and welding in the full floor panel with hat channels already installed... but so far it looks like only one replacement is available... the one with either the Omix or  MD Juan sticker.  Are there any US made options that may be of higher quality?  I have been able to find some misc pieces that are made in the States that are better quality but have not found anything for the floors.  Thank you!