The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Ryan_M
« on: April 11, 2014, 11:30:53 AM »

I was hoping that was the case. I wish I had been smart enough to ask that question BEFORE the body work on my 3A was done. It has so much body filler to smooth out what should have been left alone that it looks like a frosted cake.....
Posted by: F Bill
« on: April 10, 2014, 08:00:59 PM »

Pretty much ship them imperfections, spot welds, and all... that is one way a restoration can actually go too far.

There may have been very minor use of lead but I haven't seen any on mine anywhere..

At one point Willys supposedly left off even primer if that tells you anything about their priorities... :D
Posted by: Ryan_M
« on: April 10, 2014, 07:40:05 PM »

Anyone know if body filler of any type was used during original 3A assembly? Or did they just ship 'em out 100% metal, imperfections and all?