The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: 64CJ5
« on: October 14, 2018, 07:27:18 PM »

Shane,  To answer your question yes I have installed a Pinto engine in my '52 M-38.  I know there are others.  Novak supplied most of the parts for my conversion.  My Jeep came to me with out an engine.  After I started with the Pinto I found a Chevy 4 cyl. and three original Willys engines.  Novak is easy to work with and knowledgeable.
Posted by: NoShaneNoPain
« on: September 26, 2018, 02:20:34 PM »

Hey, I just wanted to share a video of a recentish trip I took with the Willys. I have had several shakedown runs and I figured it was time to see what I could do with it. It was incredibly muddy (like wheelin in play-doh) and for the first time I wished I had a bit more power going up muddy hills. Starting to get bad ideas of an engine swap.

Has anyone here swapped in a 2.3l ford engine or 4.3l chevy engine?

Here's a link to my video.

https://www.youtube.com/watch?v=x_7LjqXDoro