The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Carls_jeep
« on: September 22, 2013, 08:35:27 PM »

keep on wrenchin'.
Posted by: PaulS
« on: September 22, 2013, 07:36:04 PM »

I finally feel like this project is going somewhere.

I just finished assembling the rear axle, after replacing every seal and gasket, along with the carrier and shaft bearings.  The brakes have a lot of new parts, too--everything that comes in the overhaul kit from Walcks.

Only one part got wrecked in the process--the pinion seal, which is, of course, the very last thing I was installing.  I put it in backwards.  ::)  Damaged it trying to get it in, and there was no way it was coming out intact either.  Took me a few minutes to figure out what I had done wrong.  Oh well, I just used the one I had bought for the front.  I've got more things to order before I can finish the front anyway.

Thanks to everyone here--without your help I wouldn't have gotten this far!  And I know there's a lot further to go, so expect the questions to continue...

-Paul