The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: garage gnome
« on: July 02, 2013, 07:58:53 PM »

Only thing I have to do is fix the bent crank. Notice the wobbly flywheel (near one). It is an easy fix though.
Posted by: garage gnome
« on: July 02, 2013, 07:43:57 PM »

It could have ran a washing machine, corn grinder, coffee grinder, butter churn, yarn spinner, ect. Any little odd job that you didn't feel like cranking by hand.

Just sitting idle with no load, they don't use much. I'm sure they would use a lot more when worked than a modern engine doing the same task.

Pascal, this little guy fits in the back of my '53 nicely, so I can bring it along to the one car show I go to and whatever else I take the jeep to. It is also nice to bring to engine shows if they are only one day and I don't feel like lugging the Famous and Titan to.
Posted by: johnrb3b
« on: July 02, 2013, 09:57:39 AM »

I've always wondered about those old stationary engines. How do they compare with modern engines for effeciency when continuously driving a water pump or a generator?

When I drove the Alaska highway back in 1972, every gas station/store/motel along the old gravel route had a vertical, single cylinder engine driving their generator. Except for one place where we stopped for gas and I heard a very different sound coming from their generator shack. It was a new, 4 cylinder - looked like a little Jimmy.
I wish I had asked the guy how his fuel consumption changed when he switched to the new engine.

Do you have any idea how they compare?
Posted by: Quebec Jeep
« on: July 02, 2013, 08:17:25 AM »

Cool! Are you using those old motor only for show? I know your famous ice cream machine but I wonder what will be the used for this kind of small motor.
Posted by: NoCoWillys
« on: July 01, 2013, 10:10:19 PM »

Seems to be running good!  Is that off a washing machine perhaps?
Posted by: garage gnome
« on: July 01, 2013, 07:50:04 PM »

I picked this guy up yesterday, a little 1HP Maynard. It has lovely original paint and is small enough that I can put it in the back of my jeep and take it to shows.

[media]http://www.youtube.com/watch?v=bRKJJamST2E[/media]