The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: garage gnome
« on: April 10, 2013, 10:23:52 AM »

That's ok John. We'll just get our own tooling eventually. We're still learning. I know some basic stuff about it.  We'll get there. ;)
Posted by: duffer
« on: April 10, 2013, 09:20:50 AM »

Nate, that will open up almost as much potential as a lathe.  Just makes some things that are really problematic really simple.  As far as tooling, MSC/Enco is about as cheap as it gets.

I have more than a life time's worth of end mills.  One of the neighbors that owned a manufacturing plant in town had a garage sale about 5 years ago and I got 25-30 lbs of sharpened end mills-about every size/configuration there is and most are Cleveland.  Sorry-don't want to get rid of them yet.
Posted by: James P
« on: April 09, 2013, 05:39:41 PM »

I am very jealous.  :o
Posted by: garage gnome
« on: April 08, 2013, 09:01:27 AM »

Yeah, those single phase anvils are hard to find, just like muffler bearings! ;D

It is a real Bridgeport. It came will all the collets and some end mills. That is about it. We will have to get some of those clamps for it and a few other tools.

I'm familiar with msc and McMaster Carr stuff. That's it.
Posted by: F Bill
« on: April 08, 2013, 08:07:25 AM »

Wow, A single phase Anvil.. Most of those old anvils are three phase, you got lucky! ;D

But seriously... Bridgeport clone? Any tooling? I need to send you something to mill today....I got a quick attach tool post from my Atlas and I need to get the T nut milled to fit the compound t slot.
Have you got all the catalogs from the places like Little machine shop, Tools 4 cheap, CDC tooling?  Some even sell raw castings for engine projects. Way too easy to spend a lot of $$ on tooling.
Posted by: garage gnome
« on: April 08, 2013, 07:52:45 AM »

My dad found this on Craigslist. It was converted to single phase already. I have a project in mind for it, a single valve engine to go with my home built engine.