The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Carls_jeep
« on: August 29, 2012, 03:36:11 PM »

The way it's looking I will try to make it a two day trip. I may get in Blanding late Friday night. It all depends on how much driving time I want to spend.
Posted by: bretto
« on: August 29, 2012, 12:31:36 PM »

Good to hear Carl, hope your drive is enjoyable. �Are you doing this drive in 2 or 3 days? �Either way thats a lot of windshield time.
Drive safe and see you soon.
Brett
Posted by: NoCoWillys
« on: August 29, 2012, 12:03:47 AM »

Very nice. Thanks.  We don't have tons of water here, but the mountain streams here in Colorado can be surprisingly deep.
Posted by: Carls_jeep
« on: August 28, 2012, 11:42:53 PM »

I took a photo of the inside and outside of the rear cover modification I can post. I could take a photo of each hose setup but that is not needed. I pulled the vent out of the front cover and put a hose barb in and ran a hose up the side of the radiator with clamps about even with the top of the fender. The rear setup has an elbow with a barb in it and a hose going forward, over the frame and up a hole I cut in the floor with a 1/2" conduit cutter. The hole is 7/8" diameter for a grommet to protect the hose and the hose is clamped to the side of the right rear fender behind the passenger seat. The top of each hose has a barb fitting that I screwed the vent into. You need to allow some slack for the travel of the axle so it don't rip the hose off and route it so it's protected as much as possible.



Posted by: NoCoWillys
« on: August 28, 2012, 09:43:41 PM »

Nice!  Do you have any pics of the deep water vents?
Posted by: Carls_jeep
« on: August 28, 2012, 04:41:22 PM »

Annabel now has a winch and high water ability. I put John Deere Corn Head grease in the steering knuckles, removed the rear axle cover and modified it for a vent, welded the vent hole in the axle tube and installed deep water vents. Tomorrow I will load her on the trailer and pack up everything and head for Utah Thursday morning.

YEEEEEEEEEEHAAAAAAAAA