Go Devil 134

The power and torque of the L-Head engine is arguably the main reason Willys won the contract with the DOD to produce the MB used in WWII. It doesn't seem like much by todays standards, but it out performed the engines used in the Ford and Bantam prototypes. The MB used a different carburetor from the civilian models and currently I do not have the percise specs on it, but it is right in this same range.

The L-Head is known as the L-Head becase the valves for the exhaust and intake are in the block. Most engines used in automobiles today have valves in the head. This design gave it the advantage of having a relatively low profile. Part of the DOD specifications required the vehicle to be able to drive under an object that was about 3 feet high.

The L-Head engines uses a cast iron block and cylinder head with 3 main bearings and mechanical lifters. The "Go Devil" engine earned its fame in the MB use in WWII. The L-Head continued to be used in the post War CJ-2A, Willys Wagon, Willys Pickup, CJ-3A, M38, and DJ-3A. The specifications are slightly different presumably due to carburetor and compression differences between the engines. The L-Head used in '45-'50 CJ-2As and '49-'50 CJ-3As is rated the same.

 

L-Head 134 4 Cylinder
Bore x Stroke 3.125" x 4.375"
Displacement 134.2 ci(2.2L)
Compression Ratio 6.48:1
Horsepower (gross) 60@4000rpm
Torque (gross) 105@2000
Main Bearings 3
Valve Configuration L-head
Fuel Carter WO-596S 1bbl downdraft